[Free] 2018(June) Dumps4cert Cisco 400-101 Dumps with VCE and PDF Download 201-210
Dumps4cert.com : Latest Dumps with PDF and VCE Files
2018 May Cisco Official New Released 400-101
100% Free Download! 100% Pass Guaranteed!
CCIE Routing and Switching (v5.1)
Question No: 201 – (Topic 2)
Which feature can mitigate hung management sessions?
-
Contr枚l Plane Policing
-
the service tcp-keepalives-in and service tcp-keepalives-out commands
-
the servic锚 tcp-small servers command
-
vty line ACLs
Answer: B
Question No: 202 – (Topic 2)
Which DHCP message type 莽loes the DHCP Server send to a client to confirm its allocated IP address?
-
DHCPACK
-
DHCPOFFER
-
DHCPDISCOVER
-
DHCPREQUEST
Answer: A
Question No: 203 – (Topic 2)
Which attribute is not part of the BGP extended ecommunity when a PE creates a.VPN- IPv4 route while running OSPF between PE-CE?
-
MED
-
OSPF network type
-
OSPF domain identifier
-
OSPF route type
-
OSPF router id
Answer: B
Question No: 204 DRAG DROP – (Topic 2)
Drag and drop each multicast protocol from the left onto the matching description on the right. Select and Place:
Answer:
Question No: 205 – (Topic 2)
Which statement is true about IGMP?
-
Multicast source send IGMP messages to their first-hop router, which then generates a PIM join message that is then sent to the RP.
-
Multicast receivers send IGMP message to signal their interest traffic multicast groups.
-
IGMP message are encapsulated in PIM register message and send to the RP.
-
Multicast receivers send IGMP message to their first-hop router, which then forwards the IGMP message to the RP.
Answer: B
Question No: 206 – (Topic 2)
163 QUESTIN TEXT IS NOT AVAILABLEwhich three statements about EIGRP and BFD are true ? (choose three)
-
BFD is independent of the routing protocol,so it can be used as a generic failure detection mechanism for EIGRP.
-
Some parts of BFD can be distributed to the data plane,so it can be less CPU-intensive than reduced timers, which exist wholly at the control plane.
-
Reduced EIGRP timers have an absolut minimum detection timer of 1-2 seconds; BFD can provide sub-second failure detection
-
BFD is tied to specific routing protocols and can be used for generic fault detection for the OSPF,EIGRP and BGP routing protocol
-
BFD is dependent on the EIGRP routing protocol,so it can be used as a specific failure detection mechanism
-
BFD resides on the control plane,so it is less CPU-intensive than if it resided on the date plane
Answer: A,B,C
Question No: 207 – (Topic 2)
How does an IPv6 host automatically gen猫rate a global address?
-
It prepends its interface identifier to the network prefixs contained in Router Advertisement messages
-
It appends its interface identifier to the network prefixs contained in Router Advertisement messages
-
It appends its interface identifier to the network prefixs contained in Router Solicitation
messag s
-
It prepends its interface identifier to the network prefixs contained in Router Solicitation messages
Answer: B Explanation: QUESTIO.N 7
Which statement about the feasible distance in EIGRP is true?
-
It is metric that is support by the best next hop toward the destination
-
It is the maximum metric that should feasibly be considered for installation in the RIB C.It is the smallest metric toward the destination enc#39;OuntereD… … time the destination went from Active to Passive state
D.It is the maximum metric possible based on the maximum hop count that is allowed Answer: C
Question No: 208 – (Topic 2)
Which two options are benefits of Metro Ethernet?(Choose two.)
-
It supports CHAP authentication.
-
It includes a comprehensive framing mechanism.
-
It integrates seamlessly throughout the enterprise.
-
It can negate link parameters such as frame speed
-
It provides lower cost per-port than other WAN technologies
Answer: C,E
Question No: 209 – (Topic 2)
Which option is the default LACP load-balancing algorithm for IP traffic on Layer 3?
-
the source and destination IP address
-
the source IP port
-
the source and destination MAC address
-
the destination port
-
the destination IP port
Answer: A
Question No: 210 – (Topic 2)
Refer to the exhibit.
If R1 and R2 cannot establish an OSPF neighbor relationshipwhich two action can you take to (Choose two)
-
Configuration PPP authentication under the R2 Gigabitethemet 0/1 interface
-
Change the ip local pool command on R2 to ip local pool pooh 192 168 1 2 192 168 15
-
Configuration R1 to send the username and password on the Dialer 1 interface
-
Change the PPP authentication to CHAP authentication
-
Configure PPP encapsulation under the R1 virtual-tempi at interface
Answer: C,E
100% Dumps4cert Free Download!
–Download Free Demo:400-101 Demo PDF
100% Dumps4cert Pass Guaranteed!
–400-101 Dumps
Dumps4cert | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |